Hi there,
I'm trying a serial cable http://ciclamab.altervista.org/hard.php?lan=it and I'm properly receiving the logs from the router but I can't type anything on the console.. it's read-only.
I can't check it with the oscilloscope at the moment.. am I doing anthing wrong or the G624T serial interface is actually supposed to be working in read-only mode?
thanks
G624T serial read only?
- rokafeller
- Regular
- Posts: 71
- Joined: Wed Jul 22, 2009 8:57 pm
- Location: Italy
G624T serial read only?
Running D-Link DSL-G624T, PSP bootloader in place of the original Adam2, RouterTech Firmware v2.97. OpenVPN and port knocking services activated.
Re: G624T serial read only?
Definitely should be able to type - gives you a command line interface same as telnet/ssh .
Suggest you have a wiring problem. You can usually test your cable in a loopback mode connecting tx and rx via a resistor.
Suggest you have a wiring problem. You can usually test your cable in a loopback mode connecting tx and rx via a resistor.
- rokafeller
- Regular
- Posts: 71
- Joined: Wed Jul 22, 2009 8:57 pm
- Location: Italy
Re: G624T serial read only?
thanks, I'm going to check the wiring.
cheers
cheers
Running D-Link DSL-G624T, PSP bootloader in place of the original Adam2, RouterTech Firmware v2.97. OpenVPN and port knocking services activated.