I have searched the forums for an answer but not found what I am looking for.
I have a D-Link G604T that now has RT firmware installed on it.
My question is is there a way to set the target SNR to below 6db?
I was/am using a Netgear DG834v4. I can set the target SNR to 1db witch gives me a 24575kbps sync vs 18-21 ish and is 100% stable.
But My IP TV wont work with the Netgear as I can not set up a 2nd virtual bridged connection with a vci/cpi of 0/65 for it to work but I can on the G604T
So, Is it possible at all? I dont think it is as its not a broadcom chipset but thought id ask just in case
Support forum for routers of all shapes and sizes. As long as it's router based and doesn't fall into the other categories, this is the place to ask your questions.
1 post • Page 1 of 1