Wag200 linksys ver 2.97 config for publish a LAN to WIFI

[cristiaw]

Hi Folks,

I need do a questions. i Have a router linksys wag200 with versión 2.97, this Works perfect.

I need to config this router for a LAN of my work publish to WIFI so who is connected to wifi can to enter my work.

I did connect lan cable (rj45) to port 1 Ethernet. But where can to config in the routertech menú ?

How can do it ?

Sorry by my english!!

Thanks in advance.
Christian

[thechief]

You need to explain how your entire network is configured.

[cristiaw]

You need to explain how your entire network is configured.

First thanks for answering.

It's hard to explain what I do ... but it is easy to do with any router that has no ADSL modem.


In an router without adsl model, the WAN input plugs a network and that network is published on wifi.


however, the input router WAG200, the port WAN is ADSL.

I need to plug a network in another ethernet port and that port published in the wifi.

Is that possible?


The ADSL modem should disconnect.

thanks
Christian

[thechief]

Assuming that the router is in the same IP range as the office network (e.g., 192.168.1.x), try the following;

1. Delete all the connections in the wag200g (or reset to defaults)
2. Go to Setup->Lan configuration->Configure
3. Tick "Use the following Static IP address", and give the router a static IP address (e.g., 192.168.1.253); this is what you will use to access the web configuration of the router afterwards
4. Tick "Server and Relay Off".
5. Save and reboot
6. Connect the office network to a LAN port on the router (the DHCP will be managed by the office network's server).
7. Hope for the best.

If this doesn't work, then you may need an ethernet router (e.g., the D-Link DIR-615, running DD-Wrt; you can get the device very cheaply on Ebay, but you may need to install DD-Wrt on it yourself).