I need some help figuring out what's going on with these Tik's.. My network topology is attached. Currently, the traffic for 192.168.5.0/24 follows the path R5, R6, R1 and the traffic for 192.168.4.0/24 goes R4, R1.
I want the 5.0/24 to follow R5, R3, R4, R1
I want the 4.0/24 to follow R4, R3, R2, R1
I set the local-pref value to 500 on R5 F0/0 outbound. R3 learns about the new local-pref value. However none of the other network does. And the data continues to flow R5, R6, R1..
I set the local-pref value to 500 on R4 F0/1, and R3 learns about the new local-pref value, but it still does not propagate to any other routers inside the same internal AS.
What am I doing wrong? R1 still shows that route with a Local-Pref value of 100.. My understanding is LP is iBGP inner-as wide attribute.. I want traffic to flow like the blue graphic, not the red graphic. Thanks everyone!
Support forum for routers of all shapes and sizes. As long as it's router based and doesn't fall into the other categories, this is the place to ask your questions.
1 post • Page 1 of 1