I tried upgrading to OSwave firmware on my Dlink Dir300
Everything was completed perfectly until the last firmware update took 10-15mins
I got annoyed and disconnected the ethernet cable.
The Dlink power led and ethernet leds are on when i connect it to the PC
So its only half dead.
I cannot access recovery interface as well...
Any solutions please
Cannot Connect to DIR-300 after OSWave Firmware[Not Bricked]
Re: Cannot Connect to DIR-300 after OSWave Firmware[Not Bric
Moved to the firmware forum
Kieran
"Indeed!"
Invaluable links: Forum Rules | Networking Guides | FAQ | Site Search | Forum Search <-- Use it or feel my wrath!
No support via PM, please ask your questions in the forum!
"Indeed!"
Invaluable links: Forum Rules | Networking Guides | FAQ | Site Search | Forum Search <-- Use it or feel my wrath!
No support via PM, please ask your questions in the forum!
Re: Cannot Connect to DIR-300 after OSWave Firmware[Not Bric
OSWave looks to be on dodgy ground re GPL compliance,
https://forum.openwrt.org/viewtopic.php?id=13549
if you have purchased a version of Linux from them, I suggest you get support from them.
dd-wrt, as you know, also have firmware which supports this router
http://www.dd-wrt.com/wiki/index.php/DIR300
https://forum.openwrt.org/viewtopic.php?id=13549
if you have purchased a version of Linux from them, I suggest you get support from them.
dd-wrt, as you know, also have firmware which supports this router
http://www.dd-wrt.com/wiki/index.php/DIR300