Hello.
I am using a DSL connection which carries IPTV stream (UDP perhaps) as well.
In company provided modem, which is by Huawei, I set ppoe connection for internet. And a simple bridge connection for IPTV.
Then, i have to group ethernet port 1 and IPTV interface (bridge connection with designated VPI & VCI) together in one port mapping group.
Then, if i connect IPTV STB to that ehternet port, IPTV works. On that ehternet port, there seems to be no DHCP server enabled. But i dont set any static/manual LAN IP settings either.
On other ehternet ports, internet works as usual.
How do i do that on my Aztech 605EW with latest Routertech firmware?
Can i make one ppoe connection and one bridge connection (both with their own VPI and VCI) at the same time?
How do i group network interface of bridge connection and a lan port together?
How to set IPTV
Re: How to set IPTV
i dont have an iptv setup
but here are some guides which are not specifically for you
but might help you setup iptv
http://www.tpg.com.au/iptv/modem-setup- ... k-dsl-502t
http://avenard.com/iptv/TPG_and_IPTV/Setup.html
but here are some guides which are not specifically for you
but might help you setup iptv
http://www.tpg.com.au/iptv/modem-setup- ... k-dsl-502t
http://avenard.com/iptv/TPG_and_IPTV/Setup.html
Re: How to set IPTV
thank u for the links.
I have an Aztech modem with Latest Routertech firmware in it. The config is different here.
I have an Aztech modem with Latest Routertech firmware in it. The config is different here.