I tried to flash my Zyxel P-334WT with the latest firmware. But unfortunately something went wrong. I think, I turned off the device to early. Now the PWR-LED is blinking green for about a minute and then disappears and the router does nothing.
When linking LAN1 of the router with a NIC, WinXP always shows "No network cable connected" (or similar - I see the message in german). Needless to say that I cannot even ping the router. I tried a tool named Adam2App (aka TI Remote Application), but cannot get a connection because NICs in WinXP seems to have no active IP-address when there is no cable connected (I cannot ping my own NIC).
All about firmwares for routers. Support for RouterTech firmwares is here too.
1 post • Page 1 of 1