The ADSL light on the modem keeps on flashing and then going out.
Details from the Router Log:-
DSL Carrier is training
DSL Carrier is training
DSL in Sync
DSL Carrier is up
---}}} Start of connection delayed for 44 sec
PPPoA launch delay.
DSL out of sync
DSL Carrier is down
PPPoA Launch after conn delay timeout ...
pppd 2.4.1 started by root, uid 0
Default Asymmetric MTU for ppp0 1500
Connect: ppp0 {--}
PPPD Successfully Started
LCP: timeout sending Config-Requests
Connection terminated.
DSL Carrier is training
DSL Carrier is training
Details from Modem Status:-
Connection Status Connecting...
Us Rate (Kbps) 0
Ds Rate (Kbps) 0
US Margin 11
DS Margin 0
Trained Modulation T1413
LOS Errors 21
DS Line Attenuation 35
US Line Attenuation 19
Peak Cell Rate 0 cells per sec
CRC Rx Fast 0
CRC Tx Fast 0
CRC Rx Interleaved 0
CRC Tx Interleaved 0
Path Mode Fast Path
DSL Statistics
Near End F4 Loop Back Count 0
Near End F5 Loop Back Count 0
However, I am able to connect with a Speedtouch 330 USB modem.
The margin info with this is:-
DSLUptime 331
ErrorredSeconds 2
LossOfFraming 2
LossOfLink 0
LossOfSignal 2
PhysicalLinkStatus Up
ReceiveAttenuation_dB 34
ReceiveMargin_dB 31
RxOutputPower_dBm 0
SendAttenuation_dB 20
SendMargin_dB 31
I have tried plugging the NEWLINK directly into the master socket and get the same repeating ADSL light flashing then going out.
Any suggestions gratefully received.
Connection problem with NEWLINK Wireless ADSL2/2+ Router
Re: Connection problem with NEWLINK Wireless ADSL2/2+ Router
Looks like the wrong modulation type has be set, Try it set to "multi mode".gerbill wrote: Trained Modulation T1413
May be a better setting but depends on which country, who the ISP is and what speed broadband you have.
Re: Connection problem with NEWLINK Wireless ADSL2/2+ Router
It is set to multi mode.
I have seen various different trained modes in the Modem Status screen (GLite, Gdmt) - I assumed this was just because it was trying all the different modes available?
I have seen various different trained modes in the Modem Status screen (GLite, Gdmt) - I assumed this was just because it was trying all the different modes available?