Hi there.
I have just tried to use the telnet scripter to send a couple of commands to a satellite router, but have not been very successful.
Hopefully some one can see what i am doing wrong.
so the r:/test.txt is:-
HOST 192.168.128.100 1829
SEND "at\n"
WAIT "OK"
The output file shows:-
Checking Script ( clearing output file)
Running script
opening connection.
running a wireshark trace i can see the syn, SynAck and syn sent, and that is it. ( i get the same if i use MS telnet)
The strange thing about the router is that when you connect , there is no prompt, ( by design) hence the AT command sent to get some reaction and give a point to start.
I am getting a different issue with TST10, although where by i get past the AT and send AT_igps? and get a reply, but it doesnt see the OK and hangs at that point.
I have tried adding a delay before the At command, but again it didnt work.
Os is XP
Thanks for any advice
regards
Andy
Ts.exe question
-
- Newbie
- Posts: 1
- Joined: Thu Dec 29, 2011 6:49 pm